650 Series Remote Siren
  • Overview
  • Request Information
  • Specs
  • Buy

To order product literature, visit our Mulitmedia site.

Request Info

*Request:
Contact Info:
Salutation:
*First Name:
*Last Name:
Department/Company:
Address:
Address cont.:
City:
State/Province:
Zip/Postal Code:
*Email Address:
*Phone:
Action
Contact Request:
How you heard:
Please send me future information or news and sales promotions via e-mail.
Comments:
 
* denotes required field

Technical Specs and Approvals

Input Voltage: 11VDC to 15VDC
Polarity: Negative Ground Only
Operating Temp.: -30°C to +65°C
Standby Current: < .22 amperes
Separating Current: 8 amps (nominal)
13.6V battery, 11 ohm load (no lamps on)
Frequency Range: 725 1550Hz
Voltage Output: 62-66V peak-to-peak
Dim. (L x W x H): Amplifier(without base) - 8.5 in x 5.5 in x 2.0 in
(21.6cm x 14.0cm x 5.1cm)
Control Head - 4.5 in x 2.0 in x 1.0 in (11.4cm x 5.1cm x 2.5cm)
Ship Weight: Control Head - 0.5 lbs (9.25 kg)
Siren - 6.5 lbs (3.0 kg)

Warning

Audible Equipment may produce LOUD sounds necessary to request the right-of-way. Audible equipment may cause hearing damage. Wear hearing protection. Refer to the Installation Manual or call 800/433-9132 for further instructions.

Important Warning for Police Boats and Fire Rescue Boats

It has come to our attention that police boat and fire rescue boat sirens and speakers may subject persons operating those craft to sound pressure levels that can cause permanent hearing loss. We recommend that speakers be located as far forward on the boat as possible, as recommended in the SAE Recommended Practice J1849 "Emergency Vehicle Sirens". However, unprotected exposures of a sufficient duration to properly located siren speakers can still create a risk of hearing loss.

It is our recommendation that your siren speakers should be relocated and persons operating these craft should wear hearing protection when using the siren system.

Failure to comply with these recommendations may result in temporary or permanent hearing loss to operators and passengers of these vehicles.

Where to Buy

Select a Market. Select a Region.
Select a Country. State/Prov

Federal Signal’s 650 series siren allows for all sound and light functions to be enabled by rubberized push buttons located on the unit’s compact and easy to use microphone control head. Ten rubberized push buttons control three progressive “slide switch-like” positions, on/off, PA, Air Horn, Peak-and-Hold, tone switching, and up to 30-amps of additional auxiliary power.

The 650 series amplifier comes equipped with eight 10 amp light or auxiliary relay connections, is horn ring control ready, and has it’s own bracket mount to allow for quick and easy removal or replacement. This remote siren provides 100-watt speaker output and can operate from any 12-volt negative ground vehicle electrical system. 

  • Full featured 100-watt remote siren with PA light control 
  • Integrated microphone and switch controls in handset
  • Progressive push button control mimics slide switch action 
  • Eight 10-amp light and auxiliary relay postions